Search results

Hi Everyone, We have a 2017 350 Sundancer with 8.2l merc. mag. axius and Vessel View 4. We woke this morning on our mooring with nearly entirely dead batteries for "the house". The engines started when keyed on and shortly after the lights, blower, etc. began working as well. We got a "low...

We have a 2017 350 Sundancer with 8.2L Merc Seacore engines. Is it true that the port engine needs to be pulled out just to change spark plugs? (This is what one of the mechanics told us) If so, this could be the worst design in Sea Ray history!

Hello everyone, We have a 2017 Sundancer 350 with 8.2L Mercruiser Mag with Axius and VesselView4. Our autopilot has started to intermittently shut off. It disengages and gives a series of alarm beeps, but shows no error in the error log on the VesselView. Any thoughts, idea, or fixes? Much...

Hi All, We have recently had a bunch of work done and had some error messages that we were getting. Our mechanic was able to get them cleared for a short time, but we seem to be back to an error that he can't clear. The message shows a port engine trim sensor error. Our guy doesn't think its...

Hi everyone, Running engines at idle today and the starboard coolant pressure was very high. RPM's didn't make a difference. Temperature on both engines were the same. 8.2L Mercruiser Seacore Mag, VesselView4. Any advice? (See photo) Much Appreciated

Hi everyone, We have a 2017 350 Sundancer with the heat/ac system. The unit has been somewhat sporadic, but was working overall until last night. The heat came on and got up to about 66 degrees and then wouldn't go any higher. There was a steady discharge water flow while working. When I tried...

Hi All, We have 2017 Mercruiser 8.2 Mag SeaCore I/O engines. We are receiving fault codes on our starboard engine. 1. Exhaust System oxygen sensor not working properly 2. Engine misfire....service engine soon Our mechanic replaced all 4 O2 sensors and ran the engines. He said there is no...

Looking for advice here ..... Last weekend I was pulling out of our dock with the Axius joystick. Everything was fine while backing. When we cleared the slip, I pushed the joystick slightly forward to stop our rearward movement and spun the joystick to port in order to spin the bow. As soon as I...