I have a 14 x 19 michigan prop that goes to my 1985 260hp alpha one drive, that has a spun hub. I would like to have the props re-hubbed in lieu of buying new props, but im hearing different stories on why not to re-hub a prop and break down and just buy new. Is there any valid reason why I...
Im looking for some advice on a prop issue. I have a 30' dancer with alpha one drives, when i removed my props for the winter season, I noticed that one of my hubs was depressed approx 1/2" when compared to the other. To my best guess, I probably have a spun hub or at least getting close to it...
I have an 85' 30' Sundancer with alpha one drives. When I winterized the engines this fall, my starboard engine showed a temp. of over 200 deg. when the normal temp. should have been 145 degrees. I always pump through extra antifreez just to be sure, in this case it was 6 gallons. My question...
I just had both of my Alpha One drives gone through this winter, pressure tested, new water pumps, impellers, orings...etc. I have noticed on only one of the drives, that a small amount of oil is leaking from a small hole on the bottom of the drive located on the leading edge, on the opposite...
I have taken my drives off this winter to have them gone trough and such. As spring approaches here, I would like to paint them prior to putting them back on the boat. Does anyone have any recommendations for type of paint or procedures.
Thanks in advance
Looking to purchase a well cared for hatch air for a 85'30ft Sundancer....should anyone know of one, please email me at sydison@aol.com
Thanks in advance
1985 30' Sundancer
SYDISON
Hello from Ohio....My wife and I are new to this forum, but are looking forward to it. We have a 1985 Sundancer that we keep in Marblehead, OH. This is our first boat, and have had it three years now. We have 2 younger daughters, so it's been a great family experience.