I realize you posted this sometime ago,however; did you or any other members come up with a way to mount a tv antenna on a 260 that works decent and doesn't look bad?
Thanks, The rubber may be worn out I believe its the original pieces. I purchased the boat 7 years ago and I think this will be the last summer for the eisenglass so I may hold off on the drilling untill I have new fronts and sides made . Do you know if the rubber stripping is still available I...
Has anybody found a way to better secure the front and side eisenglass then with the rubber piece that slides into the grove of the windshield frame? When the weather is questionable I like to run with the center section out however the rubber seals wont hold the other panels in place when I am...
Checked with local SeaRay dealer for new set of decals. Was told they no longer make them. Has anybody had them duplicated or know where I can purchase two? They are Green & Gold.
Thanks for your help.
Ok, the stereo is in and working except for the helm remote. I removed the four screws from the power panel and slid it out as far as the wires would allow, from that access hole I was able to remove the old stereo and install the new one. The new radio was slightly larger than the old one. I...
I bought the M309 and wired remote also. I was able to get the old stereo out but thats as far as i have gotten. The weather has been so nice I had to just let the stereo go for the weekend and get out on the water and enjoy it. I will jump back on it Monday evening.
Mike, It sounds like you removed the power panel and made all your connections through that access hole, without removing the wooden panel that the radio is mounted to? I will try that this evening. Did you just wire tie the new remote cable to the old remote cable then pull the cable through at...
Hi, I'm trying to install a new stereo in my 260 and I cannot figure out how to disassemble the cabinet that holds the stereo and the power panel. The stereo I purchased requires a slightly larger hole and the remote cable is different so I need to run the new cable to the helm. If anybody has...
Hi, I'm trying to install a new stereo in my 260 and I cannot figure out how to disassemble the cabinet that holds the stereo and the power panel. The stereo I purchased requires a slightly larger hole and the remote cable is different so I need to run the new cable to the helm. If you removed...
Ok, I found the Air conditioner but it was not easy. My Aft cabin area wall panels only had two screws showing and they were about an inch above the floor panels. I removed them and then I started to feel around the edge of the panel and I could feel were there was a screw beneath the panels...
The wall with the return grill is covered with material. I do not see a panel unless it’s behind the material. If this is the correct location how do you remove the material wall to expose the hidden panel, I don’t want to break anything. I did see some panels under the cushions in the aft cabin...
Hi, can anybody tell me where the airconditioner is located on a 2000 260 SD and how to gain access to it? Mine is tripping the circuit breaker when the compressor tries to come on.