Hi
I am fairly new to Boat Ownership, I have a 540 Sundancer 2013 and the Trim Tabs are not working.
I have been trying to locate the HPU but I cannot locate it anywhere. I also pulled the switch from the Control panel but it is a singular wire that I cannot find past where it can be seen.
I...
So I searched to see if this was already on here somewhere and I couldn’t find it. That probably is more due to being a novice at navigating this forum and less to do with it not actually being posted here.
Anyway, I have an 04’ 340 dancer and today my starboard side trim tab just stopped...
Hi, I just bought a 96 sundancer and the trim tabs won't go down. At first I checked the fuse and that was blown so I changed that. After that the pump ran but had no fluid in it so I filled it and tried again. Still nothing so I crawled in there only to find that the hydraulic line for the port...
I began the pre-season clean up over the weekend and noticed my port side actuator had some fluid residue at the top (pic attached). My assumption is that it could be a bad "O" ring? Is this residue common after sitting all winter? Could there be an issue with the pipe nipple or hydraulic lines?
Hello,
I've checked everything, cleaned switch contacts, cut out and spliced pugs, removed the relay, checked both solenoid O rings and springs, and still with just one switch, either switch operated, both tabs go up or down together...?
Is there a barrier inside the pump that could leak...
I am at my wits end. I installed the relay, atc, and control unit. The system was working correctly before Install. When I put system back to original setup it still works correctly. I ran 8 wires from the relay box to the helm. When I put a loop on the 8 wire at the helm I can use it...
I have been troubleshooting my trim tab issues and have now figured out a problem...but have no idea how to fix it. Any thoughts or help would be appreciated!
I completely disconnected the Bennett trim tab motor/pump. In the ER behind the port engine, I have 5 wires...black (ground) and four to...
Hi Tom,
I have just bought a "new to me" 2008 310DA :-) - and I'm going through the list of upgrades I would like.
One of them is Auto Tab, the other is NMEA2000 output - and 3rd - I would like a TTI indication as well. (I'm an electronics engineer... so... )
But then I would clutter up my...
I started to install my Auto Tab System and found my first glitch. Apparently Sea Ray didn't use Bennett tab switches, so the wiring isn't exactly the same. The manual says to remove the Red, Green, Yellow, Blue wires from the manual tab button, but leave the Orange (power) connected.
Here's...