260 sundancer won't start

[Espos4]

Where would that breaker be?

I don’t see it in your picture.

I’m not exactly sure where it would be. Do other accessories work?
Bilge pump
Blower motor
Radio
Does the trim go up and down?

if all of these work, then you should turn your attention to the starter circuit.

 

[scoflaw]

Load test batteries?
Jumper the 2 large lugs on the slave solonoid?
Jamb a large screwdriver between the 2 large terminals on the starter itself to eliminate a bad starter. Battery to starter directly.

 

[Scott Kirkpatrick]

I don’t see it in your picture.

I’m not exactly sure where it would be. Do other accessories work?
Bilge pump
Blower motor
Radio
Does the trim go up and down?

if all of these work, then you should turn your attention to the starter circuit.

yes. all other things work. I just replaced the slave solenoid and now I hear a click sound when I try to crank it.

 

[Lazy Daze]

Battery 1 is actually 13v. Battery 2 is 13.0 as well

Is this after doing what I mentioned in post #6? Did you do anything different than I mentioned? You have be very clear with what you've done and how you've done it.

 

[Scott Kirkpatrick]

Is this after doing what I mentioned in post #6? Did you do anything different than I mentioned? You have be very clear with what you've done and how you've done it.

Yes. I'm sitting with a mechanic now at dinner and he said the starter isn't working.

 

[Lazy Daze]

Yes. I'm sitting with a mechanic now at dinner and he said the starter isn't working.

OK - I don't know what you said yes to, but good luck.

 

[Scott Kirkpatrick]

Ending result.. I am replacing the starter today. Once I replaced the slave solenoid on top next to the 50 amp breaker and attempted to crank it up, the starter pin ( probably not the right thing to call it) but it didn't engage the wheel that turns the flywheel? Sorry, I don't know all the right terms.. :|

 

[Scott Kirkpatrick]

Starter has been replaced along with the slave solenoid on the top of the engine. All works great and we're ready for the water. Also took a few minutes to fix the leak in the A/C condensate line under the cabin step.
Thanks everyone for your assistance and help in troubleshooting the issue.