50/52 Sedan water accumulating in floor compartment

[Gary B]

Thank you to everyone got all the advice and insight. Mystery leak solved! The leak we were experiencing was from both the hot water hose ends and the T to the shower supply hose that are under and behind the guest head sink. It's a relatively straight forward fix to replace the T and crummy factory hose ends. I will also be doing the cold water side while we are at it.

Does anyone know how to access the water supply hose ends on the back of the guest head shower control? I took the access panel off on the right side of the medicine chest while trouble shooting the leak and realized you can't even see the hose connections. Forget about attempting to reach them. Fo you have to remove the shower water control? If so how? Could not figure out how to remove it.

 

[Gary B]

Just saw all the typos. My apologies

 

[Havana Shamrock]

Gary, I had to remove my shower mixing valve a few weeks ago I was afraid that after removing the lines they would fall never to be seen again so. I Reached in and with one hand tied a lasso around each one and tied it off. I was figuring if I disconnect them from the sink end I could maybe pull them into the medicine cabinet far enough to cut the ends off and replace. I opened the sink access to look for leaks but nothing. The floor cubby hole had more water in it today argh!!!!!!

 

[Gary B]

If the sink is not the source of the leak and neither is the shower control the only other water line connection in that area is the fresh water supply to the guest head. If none of the connections are leaking then maybe a hose split?

How owe does the shower control assembly come off?

 

[Havana Shamrock]

You remove the handle (Allen key) pull the semi circle trim ring off and remove the 2 screws. All this after you secure the supply lines and remove them from the valve. You do this using 1 hand mind you. And DONT DROP THE VALVE you'll never see it again.
my plastic check valves inside the valve where leaking easy fix just a pain to get the thing out.
thanks for the suggestions on the water problem

 

[rlynch03]

I went though this process of replacing the leaking hose ends. What a painfully project this is... A few were done already be the PO but most were leaking a little. Replaced all of the hose ends at the two manifolds. Still need to replace the ends under the sinks, showers, etc. Definitely feel like I am making progress.

I haven't drilled a hole in the false floor in the center line of the boat yet but I think that may be worth the effort to make sure it is dry in there.