ArtWallach
Member
- Sep 12, 2011
- 160
- Boat Info
- 2000 Sea Ray 310 Sundancer
- Engines
- T300hp Mercruiser Inboards
[FONT=&]2000 310 DA w/ Inboards.
[/FONT]
[FONT=&]Anyone know the correct wiring for a SB replacement tach?
[/FONT]
[FONT=&]A friend took off 3 wires to stop the gauge from alarming for over Rev'ing. I replaced the gauge, but when I put the wires on where I thought they went, the engines cranks but won't start. When I remove them it starts just fine. Two Gray and one black not corrected. the IGN post has no wires connected If I tough either Gray wire to the ign post while the engine is running it shuts down immediately.
[/FONT]
[/FONT]
[FONT=&]Anyone know the correct wiring for a SB replacement tach?
[/FONT]
[FONT=&]A friend took off 3 wires to stop the gauge from alarming for over Rev'ing. I replaced the gauge, but when I put the wires on where I thought they went, the engines cranks but won't start. When I remove them it starts just fine. Two Gray and one black not corrected. the IGN post has no wires connected If I tough either Gray wire to the ign post while the engine is running it shuts down immediately.
[/FONT]