Bennett trim tab fuse location 2017 SeaRay 270 SDX OB

Discussion in 'Bennett Trim Tabs Vendor Forum' started by Tim9379, May 31, 2019.

  1. Tim9379

    Tim9379 New Member

    5
    May 29, 2019
    270 SDX OB 2017, Mercury 300 hp
    350 SLX 2016
    Mercury 300 HP outboard on 270 SDX
    Need help locating the trim tab fuse for my Bennett tabs on the above referenced boat. I have:
    - checked/tested all the ATC type fuses in the fuse box in the compartment under the helm regardless of how they are labeled
    - checked/tested all the fuses by the batteries regardless of how they are labeled.
    - checked to see if there is an inline fuse at the trim tab switch assembly. I followed the lines as best as possible to the point where they were bundled with others and don't see one.
    - read the owners manual but it's not clear exactly where the fuse is located, it just shows schematics that an electrician would have to interpret.

    It's under warranty but need to confirm it's not simply a blown fuse prior to bringing in and dropping off for service work.

    Thanks in advance.
     
  2. Bt Doctur

    Bt Doctur Well-Known Member

    Aug 21, 2010
    New Jersey
    Ex SRV 240 Weekender twin
    in between
    based on the ones I`ve seen and worked on the orange wire at the switch block is power
    The wire harness only supplies power to the solenoids and pump motor . There is an additional ground wire at the pump that must have a good ground to operate properly
     
  3. Bt Doctur

    Bt Doctur Well-Known Member

    Aug 21, 2010
    New Jersey
    Ex SRV 240 Weekender twin
    in between
  4. Bt Doctur

    Bt Doctur Well-Known Member

    Aug 21, 2010
    New Jersey
    Ex SRV 240 Weekender twin
    in between
    how do you change the color of the print
     
  5. paulswagelock

    paulswagelock Well-Known Member

    Oct 25, 2010
    pa
    2018 SDX 270 OB 300 Verado
    Verado 300
    I would look at the pump. I read my schematics and there is not a fuse in the panel for them. I assume they take power off the main harness closer to the pump and fuse it locally.

    If you are looking for the pump I can let you in on the secret location......

    The storage compartment / cooler on the transom walkway, you need to remove the plastic liner insert and the trim pump is in there.
     

Share This Page

Show Sidebar