Bolster (?) around forward state room bed 400SB

[Ray 40]

Again Help!
I need to remove the upholstered 'bolster' around the forward stateroom bed. I need the extra 4" in length.
I removed the screws from the 3 under brackets but it still is solid.
Is the 'headboard' bolster attached to the side boltsters?
Is the whole bolster set up 'hung' on hooks(?) from top of the bolster?
I'm trying not to tear things up.
Thanks again

Bud :smt100

 

[boatmailster]

most likely they did run screws through fabric - usually hidden inside creases

 

[Kameroo]

I need the extra 4" in length.

Sounds like a personal problem!

 

[Graham Lorimer]

Hi

Don't know if they are the same, but I recently removed the padding (bolster) from around the bed in my 1997 Sundancer and it was held on with 5 or 6 screws on each side, accessed from the underside, as well as the 4 (I think) screws on the headboard section.

Check and see if they are the same, ours came off easily after the screws were removed. There were no screws through the fabric!

GL

 

[dgrumm]

I tried to remove mine (without damaging it) with no luck. Sorry I couldn't help. If you figure it out, please post the solution.