I'm sure some of you saw my westerbeke rant in the general discussion. I'v managed to source everything, but the damn spark plug wires. Anyone have any ideas, its a 8.0 60hz. Iv tried searching for a vehicle with the same cc engine made by Mitsubishi and then searching for correct wires, but thats even an issue.
Cross reference for Westerbeke genset parts
- Thread starter kdumph
- Start date
northern
Well-Known Member
- Jan 17, 2007
- 3,526
- Boat Info
- 380 Aft Cabin 1989 Charts Timezero radar Furuno
- Engines
- Twin 454 strait shaft
http://www.rockauto.com/catalog/raf...ar=1978&a=www.bing.com+Search+for+1978+NISSAN
This is RockAuto site. If you measure the wires you can probably find ones that will fit. I have used them and the parts work. A set of wires for my quicksilver are $15.
This is RockAuto site. If you measure the wires you can probably find ones that will fit. I have used them and the parts work. A set of wires for my quicksilver are $15.
Happy Hour IV
Member
Take the old wires to a good independent FLAPS. They will be able to match something close enough that no one will notice.
One of the chains like Autozone might be able to help depending on the personnel working there. I doubt a Pep Boys could do it.
Probably any NAPA store can help.
Really nothing special about the wires. Just need the approximate length and the right kind of termination boots.
The wires are probably 8 or 8.5 mm and are RFI shielded. Most likely carbon core. Just match the material you now have.
One of the chains like Autozone might be able to help depending on the personnel working there. I doubt a Pep Boys could do it.
Probably any NAPA store can help.
Really nothing special about the wires. Just need the approximate length and the right kind of termination boots.
The wires are probably 8 or 8.5 mm and are RFI shielded. Most likely carbon core. Just match the material you now have.
Thanks for the responses guys.