jeffrey vargas
Active Member
- Feb 4, 2019
- 310
- Boat Info
- 2008 Sundancer 48
Previous
2004 Sundancer 390
2001 Sundancer 380
2000 Sundancer 34
- Engines
- Cummins QSC 8.3
Cummins QSC “low seawater flow” alarm came up today for the Port engine. Cleaned strainer, plenty of flow into strainer, Impellers only have about 80 hours on them, plenty of water coming out exhaust. Ran boat and it doesn’t get above 165 degrees and runs at the same temp as Starboard engine. So, I’m guessing it’s the sensor. Also, I can’t clear the alarm from the SmartCraft. It let me clear it a couple of times as I started and stopped the engine a few times and it cleared but now it just stays on. I’m guessing a bad sensor or wire connection.
Any ideas? Can someone point me to the location of the sensor? Is there in fact a sensor? Thank you in advance!
Any ideas? Can someone point me to the location of the sensor? Is there in fact a sensor? Thank you in advance!