Engine hatch gas struts.

[strace]

Own a 99 Sundancer 270 and need to replace the engine hatch struts. Manual shows a part # of 864173 along with 120 psi, 26.3 ext. & 16.1 comp. Have no issue locating the correct sized struts but aftermarket struts are 20lbs, 40lbs and so on. Not finding anything with a PSI rating. Anyone know what LBS rating would be used for the large engine hatch? Don't want it coming open in rough waters with a to high rated strut and don't want to kill myself with one that will not assist and stay open!

Thanks in advance for any help, much appreciated!

 

[Woody]

The factory struts on my 280DA are made by Ameritool. Look closely at yours, there is likely manufacturer info on them. In any case call Ameritool 888-870-4844 , give them the same info and they'll be able to match you up with something. https://www.ameritoolmfg.com/

 

[strace]

The factory struts on my 280DA are made by Ameritool. Look closely at yours, there is likely manufacturer info on them. In any case call Ameritool 888-870-4844 , give them the same info and they'll be able to match you up with something. https://www.ameritoolmfg.com/

I had a picture of the manufacturer info from last year but believe I deleted it. I'll have to recheck them on Monday when I get down to the boat. Quick check on their site isn't showing anywhere near the length I need for the general gas strut. Either way thanks for the info and I'll give them a call Monday and see what they may be able to come up with!

 

[Woody]

I had a picture of the manufacturer info from last year but believe I deleted it. I'll have to recheck them on Monday when I get down to the boat. Quick check on their site isn't showing anywhere near the length I need for the general gas strut. Either way thanks for the info and I'll give them a call Monday and see what they may be able to come up with!

I see some there with same extended length ...give 'em a call