When in doubt rip it out... I have been procrastinating taking this down because I haven’t found a solution to replace the plywood backer board. I need something flexible to go around the arcs and I need to fasten it from behind because I want a flat smooth vinyl front...I have ideas there.
The aft was screwed in place. The master was nail gun attached.
Does anyone have any ideas on the backer board? ...I want it about 1/4-3/8” thick and flexible
The aft was screwed in place. The master was nail gun attached.
Does anyone have any ideas on the backer board? ...I want it about 1/4-3/8” thick and flexible