Loss of depth indication in Smartcraft display

[moosepoint]

After my 2006 Sundeck 200 came out of winter storage, I noticed that the Smartcraft display no longer shows water depth when I cycle through the displays. Everything else works fine.

I'd appreciate any thoughts on how to begin troubleshooting this issue.

As an aside, am I misremembering that the display also typically shows the surface temperature of the water body I'm on? The user manual makes no mention of that readout -- and I'm certainly not getting one now -- but I thought that it was part of the display that I'd seen in the past.

 

[MT Pockets]

you may want to try a master reset. If that does not work, it sounds like a bad transducer. In my 290, it sits right in the middle of the bilge, so when you climb down there, you almost have to step on it.

 

[tbirdvet]

Mine will also show the water temp. I would go through the setup program and be sure these did not get turned off somehow.

 

[moosepoint]

Mine will also show the water temp. I would go through the setup program and be sure these did not get turned off somehow.

Yup -- running setup did the trick. Thanks much for the replies.