davidald
New Member
I am at my wits end. I installed the relay, atc, and control unit. The system was working correctly before Install. When I put system back to original setup it still works correctly. I ran 8 wires from the relay box to the helm. When I put a loop on the 8 wire at the helm I can use it with the regular setup between the pump and the sea ray wire to the trim tab switches; system works fine (proves 8 wires are fine).
When I connect the relay and atc I get the following.
Stbd down button ( no pump noise, hear clicking)
all other buttons ( hear pump noise and clicking)
Port side will go down but not back up.
Any thoughts on what is wrong?
When I connect the relay and atc I get the following.
Stbd down button ( no pump noise, hear clicking)
all other buttons ( hear pump noise and clicking)
Port side will go down but not back up.
Any thoughts on what is wrong?