Ferris
Member
Hi ferris, had the same problem, turned out the hose from the drain had loosened up, never did find a way to remove that panel,wound up cutting a small access hole about 6x4" then covered it with a small plaque. Actually looks pretty good,and leaves future access
Funny you mention that, I think I just figured it out the source as well. The drain fitting halves loosened. I sealed and tightened them and will check again soon.
I was hoping to remove it only because the lower half of that panel is soaked and sagging, hoping to epoxy it back a bit.
I liked the access panel idea because I can easily see a case where that hose needs replacing as the boat ages.