Ordering New Tabs?

Discussion in 'Bennett Trim Tabs Vendor Forum' started by TN_Ryan, Jan 10, 2020.

  1. TN_Ryan

    TN_Ryan New Member

    6
    Sep 11, 2019
    2006 Sea Ray 290 Sundancer
    Twin 5.0 MPI's W/ BIII's
    Anyone know the pet number for the 14”x14” Bennet Tabs Sea Ray uses on the 2006 290DA’s? I want to replace mine, but the Bennet representative wasn’t very helpful at all. Thanks
     
  2. Lazy Daze

    Lazy Daze Well-Known Member TECHNICAL Contributor GOLD Sponsor

    Apr 21, 2009
    PA
    Various
    Various
    They're usually quite helpful - maybe try again later. Or, ask what information they need from you?

    You can check your owner's/part's manual, but you might find that the part number is for a kit, which may include the hydraulic rams... maybe some plastic lines. It will be the internal, Sea Ray number... but maybe Bennett can use that.

    What's wrong? Are they damaged? Fixable? Maybe consider getting a set with a little more span -- if there's room... not a whole lot of space left on the transom of a 29', twin engine boat, though.
     
  3. TN_Ryan

    TN_Ryan New Member

    6
    Sep 11, 2019
    2006 Sea Ray 290 Sundancer
    Twin 5.0 MPI's W/ BIII's
    They are corroded and look pretty bad. Boat is a trailer boat now so I’m cleaning up the stern. I’ll try giving them the internal Sea Ray part number and see what they say. The guy I talked to said he needed the build sheet info from Sea Ray and not a part number. But we’ll see I reckon.
     
  4. Lazy Daze

    Lazy Daze Well-Known Member TECHNICAL Contributor GOLD Sponsor

    Apr 21, 2009
    PA
    Various
    Various
    They may be able to get you what you need based on a picture and some simple measurements, too. But definitely check to see if you can add some span... or maybe drop fins.
     
  5. dan313

    dan313 Member

    167
    Sep 27, 2009
    Long Island
    2005 270 Amberjack
    350 Mag Bravo3
  6. TN_Ryan

    TN_Ryan New Member

    6
    Sep 11, 2019
    2006 Sea Ray 290 Sundancer
    Twin 5.0 MPI's W/ BIII's
    Yeah I found that earlier. I gave that info to Bennett and they were able to find the proper part number from Bennett. So FYI the Bennett part number TPASRX1414
     

Share This Page

Show Sidebar