Skuza
Well-Known Member
I am going to install a new amp on the boat and am familiar with cars and how its done but on a boat its different. No ground to start. I am wondering where I should connect the power because I know its not done on the battery terminal itself. Same goes for the ground. I seen two large distribution terminals on the fwd bulkhead in the bilge where the pos and neg connect and then tie into accessory items. I'm thinking this would be a good place to tie in at. On the positive side there is a thing that resembles a solenoid thats kinda throwing me. Some of the wires appear to be labeled as to their use but I havn't opened up the grey tracking that they are held in to analyze it further. Anyone who's done this tell me how you did yours.