Rudder indicator on Axiom 12 not active?

[Escapade]

I've tried all summer long to get my rudder indicator on my Axiom 12 dash board to move with the wheel. No go. It shows highlighted at the bottom of the screen. Also, The gauge on my Auto Pilot and vessel view do not engauge with the turning the wheel. Any thoughts.

 

[Shaps]

What did you set on your vessel view for the source of your rudder indicator.
Also, what year? do you have pods? That will dictate what source you should use

 

[Great Lakes]

The axiom will not show rudder unless it has been updated. It was one of the things they fixed as listed in their update notes.

 

[Escapade]

What did you set on your vessel view for the source of your rudder indicator.
Also, what year? do you have pods? That will dictate what source you should use

Boat is a 2006 44 Dancer, No Pods, The Axioms are June build date and did run the updates as well. I did not set a source. Will have to go into vessel view find how to do this. Thanks, Mike

 

[Escapade]

The axiom will not show rudder unless it has been updated. It was one of the things they fixed as listed in their update notes.

I believe we are at current rev. 4.

 

[Shaps]

Im pretty sure what the axiom is displaying is driven by what the vesselview puts out over the NMEA 2k network. The key is setting the source for the rudder in the vesselview.

 

[ttmott]

Where is the rudder data? Smartcraft? NMEA2000? Old Raymarine?
If it originates on the Smartcraft network then that needs to be translated onto NMEA2000 (Some of the Vessel View products will do that.
If it originates on the original Raymarine as a part of the autopilot then it will be difficult to get onto the Axiom unless you are using the original course computer.
If you have a newer Raymarine autopilot then it should be available on the Axiom; just need to set it up to display.

 

[Escapade]

Will go into vessel view Saturday and try to configure. We have original vessel view and auto pilot.