Smartcraft gauge problem

Discussion in 'Electronics Q&A' started by JasonS, Jun 13, 2018.

  1. JasonS

    JasonS New Member

    24
    Nov 7, 2016
    Lake wallenpaupack
    2006 SeaRay 240 Sundeck
    350 Mercruiser
    Hi all, I have a 06 Sundeck with smartcraft gauges. At the bottom of the tach, is the smartcraft display. When it works normally it does a self diagnostic. Now, when I turn the boat on the screen lights up all black with no letters or numbers. Anyone else run in to this problem? The boat was just in for the trim cylinders getting rebuilt and an oil change if that matters.
     
  2. paulswagelock

    paulswagelock Well-Known Member

    Oct 25, 2010
    pa
    2018 SDX 270 OB 300 Verado
    Verado 300
    That should not matter.
    You can try rebooting it. You will need to disconnect all power to it (sometimes that means disconnecting all batteries depending on how you are wired). Typically clears up any issues.
     
  3. Espos4

    Espos4 Active Member

    559
    Jan 1, 2017
    Long Island NY
    2007 240 Sundeck
    350 MAG Bravo 3 W/DTS
    I had an issue twice last year where all the gauges were dead.

    Behind the dashboard is a round plug in the wire harness with a whole bunch of wires in it. You can access this from inside the helm storage area. Twist the collar and unplug the connector, clean with contact cleaner, reassemble with some dielectric grease, so far so good for me.
     

Share This Page

Show Sidebar