Smartcraft

[Michael Owczarek]

I recently had a blown fuse behind dash for my smart craft monitor. Fuse was replaced, but gauges still don’t work. Did a master reset of smartcraft and now monitor reads NoSt. Any ideas on why it’s not reading starboard engine.

I have a single engine 5.0 MpI Bravo 3.

 

[bobeast]

If I remember correctly, all engines shipped from the factory as a Port engine. If SC is expecting to see a starboard engine, the reset likely set the device to look for 2 (or more) engines. I think you can go through the setup and make sure only one engine is selected.