ggrimes
New Member
- Sep 1, 2019
- 5
- Boat Info
- 2006 Sea Ray Sundancer 260DA, 6.2 l Mercruiser, 5 kw Koehler generator.
- Engines
- Mercruiser 6.2 l with Bravo II drives
Hi all
I bought a 2006 SeaRay Sundancer 260 DA in the fall and had challenges with the existing trim tab. Over the winter I asked them to install the Bennet ATP controller based on good reviews and videos. The dealership initially tried to talk me out of Bennett but I had already bought it. They worked on it for a long, long time and could not get it resolved. They delivered the boat to my marina with non-functioning tabs and a note saying to do the calibration on pages 20 to 24. I cant even get the tabs to respond or for the calibration to take. I get into the calibration mode but the tabs wont go up and down as they are supposed to and therefore the calibration doesn't work. In the last step when you are supposed to see the actual position of the tabs I get the red flashing lights. The sensors are recognized with green lights on the control unit and steady yellow at the helm. I do get a flashing COMM light on the control unit and don't know if that is good or bad. I sent an email to Bennett and am trying to find an authorized service person near my marina but no luck so far. I have been googling like crazy and found one guy that had same problem but his videos didn't share any solution. Thanks for anything at this point.
I bought a 2006 SeaRay Sundancer 260 DA in the fall and had challenges with the existing trim tab. Over the winter I asked them to install the Bennet ATP controller based on good reviews and videos. The dealership initially tried to talk me out of Bennett but I had already bought it. They worked on it for a long, long time and could not get it resolved. They delivered the boat to my marina with non-functioning tabs and a note saying to do the calibration on pages 20 to 24. I cant even get the tabs to respond or for the calibration to take. I get into the calibration mode but the tabs wont go up and down as they are supposed to and therefore the calibration doesn't work. In the last step when you are supposed to see the actual position of the tabs I get the red flashing lights. The sensors are recognized with green lights on the control unit and steady yellow at the helm. I do get a flashing COMM light on the control unit and don't know if that is good or bad. I sent an email to Bennett and am trying to find an authorized service person near my marina but no luck so far. I have been googling like crazy and found one guy that had same problem but his videos didn't share any solution. Thanks for anything at this point.