Looking for suggestions on how to fill in the holes that will be left by these electronics in the wood area. I’m adding in an additional 12” screen and these will all be repositioned.
I have a new wood panel already. Bu I need to patch/fill in the 3/8 fiberglass behind the cherry veneer plywood.
My initial thought was to get a pre-made 3/8 FRP panel, cut it to size, and patch it in using some fiberglass tape and thickened epoxy. The entire helm pod tilts forward. I’d rather not have to remove all the other “stuff” (wheel, switches, controls, etc) installed to do the fix in my garage.
I have a new wood panel already. Bu I need to patch/fill in the 3/8 fiberglass behind the cherry veneer plywood.
My initial thought was to get a pre-made 3/8 FRP panel, cut it to size, and patch it in using some fiberglass tape and thickened epoxy. The entire helm pod tilts forward. I’d rather not have to remove all the other “stuff” (wheel, switches, controls, etc) installed to do the fix in my garage.