That's a Sea Ray all right. The picture posted OK but a bit small. You may have compressed it too much.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Before I get into that, a question, request for opinions.
SO the main stringers along both side of the tanks, and the structure that forms the engine bay were/ are actually glassed to the hull and sit direct on the hull. (as i would expect)
The small outer stringers by the sides of the boat sit on the hull but are not glassed to the hull.
The stringers between these two, that run from front to back were not glassed to the hull and actually sat an inch higher than the hull??? The flotation foam was formed underneath them.
I plan to bed all stringers in a wood flour thickened epoxy and tab to the hull with 1708 glass. Can anyone think of a reason why this is not how it was done at the factory. ( i have some but they are all around cheap and quick)
Great boat. I did the same rebuild on my 1975 180srv. Also have a bit of 2’-itis now.