When the boat was out of the water I replaced the trim tab actuators and added the NMEA 2000 kit (NMEA1) so the trim tab positions could be displayed on the network.
Now that it is completely integrated with the NMEA network, the device is recognized by the displays (Vessel View 7, Raymarine E120's, and Maretron DSM410 as "Lowrance Trim Tab" however the displays will not communicate with the trim tab module for calibration and nothing is displayed. I have ran the calibration sequence several times on the Maretron DSM410 with the message that it cannot communicate.....
Any experience on this?
Thanks
Tom
Now that it is completely integrated with the NMEA network, the device is recognized by the displays (Vessel View 7, Raymarine E120's, and Maretron DSM410 as "Lowrance Trim Tab" however the displays will not communicate with the trim tab module for calibration and nothing is displayed. I have ran the calibration sequence several times on the Maretron DSM410 with the message that it cannot communicate.....
Any experience on this?
Thanks
Tom