Harmon
Member
- Jun 28, 2011
- 363
- Boat Info
- Current: 2006 320DA as of 6/7/19
Previous 1997 Sundancer 250
1989 Basstracker 40HP
- Engines
- Twin 350 Horizon with Vdrives
Single 7.4 Ltr carbed
Bravo 3 outdrive
Two questions:
I'm put my B3 outdrive back on ysteday and got it slid in to place and then it stoped about an in or so and I couldn't go in any further, I wiggled and shook and turned shaft thinking it was splines. I put on two middle nuts and proceeded to alternately tighten until gear housing met up with gimbal housing, no real resistance. Is it typical?
Also, the bushings on back trim cylinders look a littel chewed up on outer/washer side, still solid though, need new ones?
I'm put my B3 outdrive back on ysteday and got it slid in to place and then it stoped about an in or so and I couldn't go in any further, I wiggled and shook and turned shaft thinking it was splines. I put on two middle nuts and proceeded to alternately tighten until gear housing met up with gimbal housing, no real resistance. Is it typical?
Also, the bushings on back trim cylinders look a littel chewed up on outer/washer side, still solid though, need new ones?