JB MARSHALL
Active Member
Over the weekend went to drop the anchor as normal, activated the main switch at the helm and then I use the rocker switch next to it to put down the anchor. I engaged the rocker switch for a few seconds lowering the anchor, paused for a second or two and then pushed the switch again and nothing happened. Had to lower the anchor from the bow with the foot switches which baffles me that they would work and not the switch at the helm.
So tonight I checked the voltage at the switch and it has a full 13 volts. Then disconnected the wires pulled the switch and checked continuity and that checked out. Went down in the engine room and checked breakers that I could see including the fuses in the closed 12V panel. So now I have exhausted all I know to check. I would really appreciate some guidance on this one.
Thank you,
JB
So tonight I checked the voltage at the switch and it has a full 13 volts. Then disconnected the wires pulled the switch and checked continuity and that checked out. Went down in the engine room and checked breakers that I could see including the fuses in the closed 12V panel. So now I have exhausted all I know to check. I would really appreciate some guidance on this one.
Thank you,
JB