Just installed a tower on my sea ray and it has a light on top does that count working while traveling at night with it or do I have to put on the standard light on the stern along with the top light ?
I've lost power to my bilge pump located midship in the galley. Its a rule pump..and the original wiring diagram from rule shows an inline fuse between the battery and the red light indicator at the helm..I cannot find it anywhere..anyone know?
What should the oil pressure be on a 240 Sundeck with a 5.0 Bravo II (OW344212) at idle, showing about 30# but at almost 4000 rpm, showing almost 60# with a newer filter and oil change (quicksilver filter)
Hello Lazy Daze.
I am new here and see you seem to top the chart with the most messages.
Could you help me with a question?
I have a 1990 270 da and see the 1992 290 da is pretty much the same boat.
The carpet for my cockpit fits good when I purchased 1992 290 da from matworks since they did not go back to 1990.
Will canvas (bimini and camper) for a 1992-1993 290 da also fit my 1990 270 da with arch?
Is there a video/instructions for installing thru hull pickup/sea strainer to water pump (with block plate on transom) .....as you have recommended in your responses for blocked intake hose (IE-Bravo-itis)
appreciate any assistance-and thanks-Tim
Hi - I have been pointed in your direction - I have a 280da (315) single diesel 2005 sundancer and I wonder if you could help me with the specifications/makers etc of the engine hatch lift - mine came without and as everyone knows these are quite heavy and would like to retro fit the lift system many thanks for any help that you can give
I purchased an 87 Sundancer 300 that was toast. I have installed 2 new marine crate motors, but my problem is I can't find a manual any where to uncluster it. Sea Ray more or less said sorry for your bad luck. They can provide an owners manual. Is there any way I can get a manual or specs for the wiring so I can get this thing running? I would appreciate any help you can give me.
The tube of hydrolic oil broke and the transmission stop working.
I repair the line and i refill the oil.
I restart the motor and the joystick don't work
The alarm said : TVM forced idle, no joystick, but the transmission work
i put down all the electricity for see if the computor was restarting the system
joy stick not working
I recently purchased a '97 Sundancer 240 with a 5.7 w/ Alpha one drive. I am replacing the engine, adding a few HP, and I am going to replace the outdrive as well. My immediate problem is not knowing what the gear ratio is for this outdrive Frankly, there is a lot of stuff I don't know about this boat. Does anyone know what the ratio might be, and who is a reputable dealer from whom to purchase the hardware?
I'm a new boater owner of a 1999 240 Sundancer. I want to charge the batteries (3) using my shore, home ac power. My battery selector switch has 3 positions.....What position should it be on? Also, do I need to turn both the AC panel on and the Inverter switch on?
There's a selector switch located inside a cabinet with a clock like face in the rear of the boat. The switch has 4 positions: 12, 3, 6, and 9 o'clock. I need help figuring what position the selector switch should be in when starting, when boating on the lake, when parked in the driveway, and when charging the batteries?
Hi Dennis. I saw your post from last year on the 3way quick disconnect fogging modification for MPI engines but I couldn't see the diagram or photos. Any chance you could email them to me? I would greatly appreciate it.