Search results

Hi, Jim, thanks. Where can I find pin 8 respectivly connector F/M36? And how about gear oil level sensor?

I have Sea Ray 300, Mj 2002 wih 5.0 MPI. Normally if I switch on ignition with the switches on dashboard, the engine alarm buzzer sounds for 1-2 sec. This is just to proof that the buzzer is OK and system is working. Port engine alarm is sounding normally but starboard engine buzzer is not...

Yes, thank you. Problem solved.

300 Sundancer Mj. 2002 120V outlet- TV, kitchen and bed outlet not working. I have 300 Sundancer, Mj. 2002. Somehow by plugging in Lap Top charger into galley AC outlet, some circuit braker seems to be blown. Now, no 120 AC on 3 outlets. 1st, drawer behind sink. 2nd, TV, 3rd, front bed. Also...

....really nobody ?

I just wondering whether some of you could help in sending me engine repair manual (pdf) Engine no. is OM 338418. I also looking for Bravo III repair manual. Who can help please. I from Germany and can not access certain sides mentioned in this post. It says it is only available in USA.

I am sure, I am not the only one! It seems a Bravo III problem. I have water coming in bilge from the steering rod (shaft). -3 Gallon in 24 hrs- What is the solution? My technician said, the engines and transom must be removed, just to change a little shaft seal

You can, but why you making it complicated? Use electrical heater:grin: If you use an 2000 W 220V on your 110V system, it will still deliver 1000 W and this should be enough for this small cabin.

Hi Peter, thanks. My bout is in Croatia. I living near Munich and Croatia is not too far, 400 miles only I never been boating Netherlands!

My davits working perfectly.:smt001 With engine, I can even walk around the dinghy and using my gangway w/o taking the dinghy off.

Thanks for your detailed information and advises:smt001 Boating and burning 1 GPM, same 10 cars together at the same time is not logical at all. I rather refer to other, personal circumstances such as my marina. They can handle boats only with max beam of 11,5 feet. Anything bigger and I would...

The thing is, you never plan a purchase of a boat as stepping stone. The desire of a bigger one comes always when with the current one:grin:. But somehow I think, the 320 is the last size I would get into for economically reasons. Cost in boating are not rising linear. They rising to the...

I thinking to upgrade from my 300 to a nice used 320. Not sure about engines 350 Mag MX 6.2 or 496 Mag.??:smt100 My current 300 Sundancer has 5.0 MPI which is just fine, but when fully loaded (Fuel, Water, foodstuff, beer:grin: and 3 poeple), she needs quite a bit of time to get on plane. Top...

I dont understand the complains on dealers and their margin. If you think it is attractive be be a dealer and these are bastards who just gain richness out of your money.... change your profession and become a dealer and you will be on the other side of the world :grin: I am not a dealer but I...

Some more new pics Feedback is appreciated :smt001

Here is the result. Cutting is finshed. Just need to drill all holes now. I ll keep posting the progress. Custom made for front and rear side:grin:

I going to make own "pull on" davits now. After extensive research, finally I decided to use so called PE-LD (polyethylene - low density) The reason are various (see here: http://www.ides.com/generics/PE/PE_overview.htm But most important is the specific gravity. of 0.93. So it float in...

Can not imagine that this boat would not suit some of your guys in US as well. So why only Europe? http://www.boattest.com/boats/Boat_video.aspx?ID=2005

I do it with a bit more pressure and try to lift the carpet slings with the waterjet. Then when dry, the carpet has much more volume and it is more fleecy. Hope your guys undersand what I mean with my poor English.

I use my home "Kärcher" high pressure cleaner! No kidding it works very well. Just reduce pressure a bit. All sand, salt and stains gone after.