Lazy Daze, I discovered that it wasn't paint, but a decal. I sprayed it with WD40, let it set then used a razor blade to remove it. Thanks for your response.
I recently bought a 176 Sea Ray and this word is painted on the inside of the boat. I checked carefully and it isn't a wrap it's individually painted letters. I'm looking for a way to remove the painted letters without ruining the finish. Are there any paint experts here ?
Sorry that it's taken me a while to get back on the forum, but I've been traveling and didn't have time to spend on my computer. I appreciate what each of you suggested. Now that the weather is looking good in Northern CA I'll try to get the boat out again and do some experimenting. The...
Thanks Boatboy, I'll try changing the settings, but 4C was where it was previously and it showed 2,000 RPM when idling, so I don't think that was the correct setting.
I took my Sea Ray 176 out today for a trial run. I have the 3.0 Alpha One . At idle the tach registered right around 600 RPM, which I believe is correct. With myself (200 lbs) and my friend (170) on board at almost wide open throttle the speedometer showed 48 MPH and the tachometer only...
Thanks all. I recognized the navigation light (very obvious), and had an idea that the chrome cover to the left was a horn, but it didn't work. After tightening a few electrical connections the horn now works and it's obvious where it is. Thanks all.
I'm not totally obtuse, but haven't had...
Does anyone know what the pressure is for the shock that holds the engine cover up? I mistakenly ordered the shock with 40 lbs of pressure that that seems way too much.Outfitters offers 10, 20, 30 and 40 lb units.
I'm sorry for asking so many questions, but I'm back into boating after many years being out, and my memory is terrible, so I'm back to learning all over again.
My engine hatch cover was missing one of the shocks that hold it up and I discovered why when I found that the top bracket that the...
Just a question from way out in left field, but can you just remove those screws and replace them with slightly larger screws? And if so, would you consider using lock tight? I know on motorcycles with high frequency vibration lock tight is our friend.
Jim and Scott, thanks both for your information. It's always good to hear from those with vase experience and consider what they've discovered.
Back in the 80's when I did a lot of boating (mostly waterskiing) I found an old Johnson 75 hp. The big old 4 cylinder engine. It had thrown a rod...
I found a mechanic with great reviews. He thinks he can take a look at my boat in about a week. I asked him to check everything over, change fluids and let me know if anything else needs adjustment or repair. I just want to start with a good running engine that I have full confidence in...
Thanks for the info Jim. I've got a lot to learn about this boat. As I mentioned above I need to have a good boat mechanic check the engine tune and I need to address the Tach and Speedo problem. Just a lot of little stuff to make things right.
Dennis, I didn't really know what to expect in the way of a hole shot or what it should take to stay on plane, but it just felt sluggish, like it was over propped, but that may also be because the engine isn't tuned as well as it should be. I'm trying to find a good mechanic to give the engine...