Replacing Fuse Block

Discussion in 'Electrical Stuff' started by argus1, Apr 28, 2020.

  1. Lazy Daze

    Lazy Daze Well-Known Member TECHNICAL Contributor GOLD Sponsor

    Apr 21, 2009
    PA
    Various
    Various
    It may depend on which year 260DA you have (you didn't mention), but it could be 8g or maybe 10g. But your manual will tell you and so will the wire - Sea Ray prints that on the wires. However, at only 20CM... either relocate the fuse panel to a better spot or follow the wire back in the rigging - there has got to be 20cm of pay somewhere. Both of those options are better than adding a connector.
     
    Last edited: Dec 5, 2021
    techmitch likes this.
  2. CharlieA

    CharlieA New Member

    2
    Dec 4, 2021
    SeaRay Sundancer 260
    Mercruiser
    It’s a good idea - will have a go. I thought perhaps the wires were cable-tied all the way along and I’d have to undo / redo that to pull through some slack. Will have a look.

    My 260 is a 2006 model. Whereabouts is the wire gauge marked?

    Thanks for your help!

    Charlie.
     
  3. Lazy Daze

    Lazy Daze Well-Known Member TECHNICAL Contributor GOLD Sponsor

    Apr 21, 2009
    PA
    Various
    Various
    :)

    The wiring is done pretty tight - but there's gotta be 20CM of slack in there somewhere that's not too far away.
     

Share This Page

Show Sidebar