Morning All,
I need to install a transducer for my Simrad GO5. It came an HDI Skimmer transducer but no installation instructions. This is a transom mount unit and I know it must be mounted level and where it will be just below the running surface of the boat so it is in the water while on plane. I was thinking of putting it here....
There is nothing on the bottom forward of this so I don't think turbulence will be an issue. Truthfully my biggest angst in this whole task is drilling a 1" hole in the transom. It would be at, or slightly above, the waterline. Any tips?
Or can I epoxy this thing inside the hull?
Thanks
Shawn
I need to install a transducer for my Simrad GO5. It came an HDI Skimmer transducer but no installation instructions. This is a transom mount unit and I know it must be mounted level and where it will be just below the running surface of the boat so it is in the water while on plane. I was thinking of putting it here....
Or can I epoxy this thing inside the hull?
Thanks
Shawn