pyro
Active Member
- Dec 4, 2018
- 287
- Boat Info
- 2008 Sundancer 290
- Engines
- Twin 5.0L MPI Bravo III
Kohler 5ecd
I'm trying to figure out these trim sender parts numbers. I have Smartcraft gauges with DTS. Currently I have a 2 wire puck on starboard and a 3 wire puck on port on each outdrive. On my old boat they used a analog sender and a trim limit. Sounds like these are a digital and an analog sender. And there is no trim limit to stop you from trimming up too much when moving?
Parts list for my drive shows three different types:
Trim Sender Analog 863187A1
Trim Sender Analog/Digital 8M0107462
Trim Sender Digital 8M0095310
The digital is labeled for newer S/Ns than mine. I think I only need a new digital gauge, and the analog gauge is wired into the boat harness but then never used since there are no analog (non smartcraft) gauges.
Will the 8M0095310 work for me? The digital only is half the cost of the digital & analog. They also look like these use different wire material. The lamp cord wires of the old design don't work for long.
Parts list for my drive shows three different types:
Trim Sender Analog 863187A1
Trim Sender Analog/Digital 8M0107462
Trim Sender Digital 8M0095310
The digital is labeled for newer S/Ns than mine. I think I only need a new digital gauge, and the analog gauge is wired into the boat harness but then never used since there are no analog (non smartcraft) gauges.
Will the 8M0095310 work for me? The digital only is half the cost of the digital & analog. They also look like these use different wire material. The lamp cord wires of the old design don't work for long.