Search results

Will a pair of these cut it for a 5.7 TBI on a 225 ? These are dual purpose type. Have heard at least 1 CCA per cubic inch is a good rule of thumb. Thanks for any comments Specifications Part NumberHD24-DP Group Size24M Cold Cranking Amps (CCA)405 Cranking Amps (CA)505 Reserve Capacity...

About time. Under some administrations the feds can get it right. https://www.marketwatch.com/story/airlines-to-give-automatic-cash-refunds-to-flyers-under-new-biden-regulation-2abcf546

aplha1 gen 2 outdrive. Seems you dint want I overdo it?

Anyone know if they would have put them on a 1999 215EC ? Will be helping someone put one on stands and would be useful for placement of stands. Thanks

Any ideas where best location for boat stands would be for a 1999 215 EC? Aft location pretty straightforward but not sure on forward set. First time getting blocked. Thanks

Maybe making them easily available to any jackass that wants one isn’t really the way go. What do you think Joel Osteen? You cater to the right wing nuts. Can’t even celebrate a Super Bowl, much less walk into a church. Time for some reasonable gun laws. Wake up- It’s not a political issue.

Do these look like a fit for sea Ray sport boats ...

Hh

Is this doable? Sr215 and looking at small Honda 2.3 to push me home if ever needed …. Comments appreciated

But I will remember: Character matters. Be careful when you choose a President. https://www.theatlantic.com/politics/archive/2020/09/trump-americans-who-died-at-war-are-losers-and-suckers/615997/

Anyone tried a good method of removing the plastic type coating that’s coming off in big pieces and recoating with something acceptable? Thanks for any suggestions.

New to me 215. The way these operate seems opposite as they should. The starboard switch operates the port tab and vice versa. I kind of can see that but ALSO, depressing the top half of the switch lowers the trim tab and pushing the bottom half raises the trim tab. Does yours operate this...

New to me 215. The way these operate seems opposite as they should. The starboard switch operates the port tab and vice versa. I kind of can see that but ALSO, depressing the top half of the switch lowers the trim tab and pushing the bottom half raises the trim tab. Does yours operate this...

Anyone try JJVs zebra mussel release spray on outdrives ? Wondering if safe to use on aluminum as its sodium hydroxide based. Bad year around here for these.

any ideas what would work best to clean up? i want to clean years of black crud all out and start over with a dry lube.

I know sounds dumb, but…. It’s a 1998 5.7 mercruiser on a 215ec. I thought it was MPI but removing flame arrestor I saw two big butterfly valves in what looks like a big carb. Can these still feed injectors or what am I looking at? I do not see injectors like I do on my 2019 v6 Nissan truck. Thanks

1998 215 EC - Anyone know where depth finder transducer would typically be installed on this boat? There is a transom mounted transducer but I believe it's for the old Humminbird fishfinder. One of manuals I have indicates factory optional Lowrance 3500 would have a thru hull type transducer...

sea ray part 0767277 for 1998 215 EC anyone have a good source for these? I know its a Perko but searching with Sea Ray part # is not yielding much

1998 215EC 5.7 Mercuiser 260hp Plastic cover on gas filter seems to have top cover that clips on to the lower cover. Very little room to move these up or down to get off. Has anyone dealt with these? Just want to remove without damaging so I can replace water separating fuel filter. Thanks.

260hp 5.7 So far so good.