stelios hondrcolos
Active Member
- Apr 11, 2021
- 178
- Boat Info
- 300
- Engines
- 350 Mag
I cannot get the little 8mm bolts on the collar zinc to bite into the ram end cap holes. It seems stripped holes is a common problem.
There is no room to tap new threads without dissasembling the ram, or get a drill in straight to add a helicoil.
Someone suggested using a 3/4 x 2 1/8 inch shaft zinc which will fit. https://www.marineengine.com/boat-accessories/anodes/CMX01M Any thoughts?
There is no room to tap new threads without dissasembling the ram, or get a drill in straight to add a helicoil.
Someone suggested using a 3/4 x 2 1/8 inch shaft zinc which will fit. https://www.marineengine.com/boat-accessories/anodes/CMX01M Any thoughts?